![]() ![]() Once this all is done, you do need to load and run the MOBO's software utility MSI Mystic Light to generate the display control signals that have to be output from the mobo header to send to the Cooler Master Controller. One thing it does not tell us clearly: many such systems require that you tell the unit to switch to external (from a mobo) input control (instead of using the box manual buttons) by holding down the top Display Mode Adjustment button #1 for about 3 - 5 sec. ![]() Pushing the Mode button #2 switches to the plain RGB Mode and the RIGHT light indicates this and it uses the RIGHT input port item F. Its manual says that when the LEFT light is on it is using the ARGB Mode and input from a mobo ARGB header using the LEFT input port item C. Note that, near the bottom front of this box there are two light indicators, one to each side. When you have it set up and turned on, then you go to the RGB / ARGB Mode button SECOND from the top. There are several other connections to make. You must connect cable F from the 4-pin mobo plain RGB header to the correct input port of the Controller - the one with 4 holes marked "MB 12V" - see the Controller manual for item coding. As I understand the way that larger Cooler Master Controller works, you can use that "translation" feature if connected properly. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |